PFXSP5690WAD / PFXSP5690WADF0H

제품 기본 정보
제품 카테고리
HMI
시리즈
SP5000X Series
화면 사이즈
12" Wide
모델
PFXSP5690WAD
글로벌 코드
PFXSP5690WAD
제품 특징
12" Wide DC
디스플레이 표시 사양
디스플레이 타입
TFT Color LCD (Ultra High-brightness)
표시 사이즈
12.1" Wide
화면 해상도
1,280 x 800 pixels (WXGA)
유효 표시 사이즈
W261.12 x H163.2 mm [W10.28 x H6.43 in.]
표시 색상
262,144 colors
백라이트
White LED (Not user replaceable. When replacement is required, contact your local distributor.)
백라이트 수명
50,000 hrs. or more (each in continuous operation at 25 °C [77 °F] before backlight brightness decreases to 50%)
조도 조정
0 to 100 (Adjusted with touch panel or software)
Brightness
1000 cd/m2 (typ.)
터치 패널 방식
Resistive Film (analog)
터치 패널 해상도
1,024 x 1,024
터치 패널 수명
1,000,000 times or more
전기 사양
정격 전압
12 to 24 Vdc
허용 전압 범위
10.8 to 28.8 Vdc
순간 정전 허용 시간 범위
12 Vdc: 1.25 ms or less
24 Vdc: 5 ms or less
소비전력
Max. 37 W
When power is not supplied to external devices: 23 W or less
Backlight OFF (Stand-by mode): 12.5 W or less
Backlight adjusted (20%): 16 W or less*1
돌입 전류
30 A or less
내소음성
Noise Voltage : 1,000 Vp-p
Pulse Duration : 1 µs
Rise Time : 1 ns
(via noise simulator)
절연내력
1,000 Vac for 1 minute (between power terminal and FG terminals), leakage current: 20 mA or less
절연저항
500 Vdc, 10 MΩ or more (between power terminal and FG terminals)

1The power consumption is the sum of the power consumption of Box Module and Display Module.

환경 사양
해외 안전 규격
CEUKCAUL,cUL (508) ListedANSI/CSA (UL508+1604) ListedATEXIECExKCC-Tick
사용 환경 온도
-30 to 70 °C [-22 to 158 °F]
When installing and wiring: -5 to 70 °C [23 to 158 °F]
보관 온도
-30 to +70 °C [-22 to 158 °F]
사용 환경 습도
10 to 90 % RH (Wet bulb temperature: 39 °C [102.2 °F] max. - no condensation)
보관 습도
10 to 90 % RH (Wet bulb temperature: 39 °C [102.2 °F] max. - no condensation)
먼지
0.1 mg/m3 (10-7 oz/ft3) or less (free of conductive dust particles on all surfaces other than the front face)
오염도
3 for front face, 2 for other sides
부식성 가스
Free of corrosive gases
Harsh environment model (Model numbers ending with "F0H") : IEC/EN 60721-3-3 Class 3C3
대기압 (사용 고도)
800 to 1,114 hPa (2,000 m [6,561 ft.] or lower)
UV resistance (front side)
Cutoff: 99% or more (380 nm)
내진동
2G, IEC 60068-2-6 compliant, 5 to 9 Hz Single amplitude 7 mm [0.28 in.], 9 to 150 Hz Fixed acceleration: 19.6 m/s2, X, Y, Z directions for 10 cycles (approximately 100 minutes), IEC 61373: 1999 (Category 1, Class B), 5≤f≤150 Hz (weight < 500 kg: f1=5 Hz, f2=150 Hz) acceleration: Up and down: 7.90 m/s2, Right and left: 3.50 m/s2, Back and forward: 5.50 m/s2
내충격성
40G, IEC 60068-2-27 compliant 392 m/s2, 11 ms, X, Y, Z directions for 3 times
내정전기방전
Contact Discharge Method: 6 kV
Air Discharge Method: 8 kV
(IEC/EN61000-4-2 Level 3)
설치 사양
접지
Functional grounding: Grounding resistance of 100 Ω, 2 mm2 (AWG 14) or thicker wire, or your country’s applicable standard (same for FG and SG terminals).
냉각 방법
Natural air circulation
보호 구조
IP66F, IP67F, Type 4X (indoor and outdoor use), Type 12, Type13
* on the front panel when properly installed in an enclosure.*1
외관 사이즈
W308.5 x H230.5 x D68 mm [W12.15 x H9.07 x D2.68 in.]
패널컷 사이즈
W295 x H217 mm [W11.61 x H8.54 in.]
Panel thickness area: 1.6 to 5 mm [0.06 to 0.2 in.]*2
질량
3.2 kg [7.1 lb] or less
Front bezel
Aluminum die-cast
Stainless steel

1The front face of the unit, installed in a solid panel, has been tested using conditions equivalent to the standards shown in the specification. Even though the unit's level of resistance is equivalent to these standards, oils that should have no effect on the unit can possibly harm the unit. This can occur in areas where either vaporized oils are present, or where low viscosity cutting oils are allowed to adhere to the unit for long periods of time. If the unit's front face protection sheet becomes peeled off, these conditions can lead to the ingress of oil into the unit and separate protection measures are suggested. Also, if non-approved oils are present, it may cause deformation or corrosion of the front panel's plastic cover. Therefore, prior to installing the unit, be sure to confirm the type of conditions that will be present in the unit's operating environment. If the installation gasket is used for a long period of time, or if the unit and its gasket are removed from the panel, the original level of the protection cannot be guaranteed. To maintain the original protection level, be sure to replace the installation gasket regularly.
Check the model number and product version (PV) on the product label. If the product version is “PV: 01” and only with one of the following model numbers, the protection level is IP66F.
Model number: PFXSP5490WAD, PFXSP5690WAD

2사이즈 공차는 +1/-0mm, 각도 R은 R3이하입니다.
패널 두께 범위에 맞추더라도, 패널의 재질, 크기에 의하여 본 제품 혹은 접속 기기의 설치 위치에 따라서 패널이 뒤집힐 가능성이 있습니다. 패널의 낙하를 방지하기 위해, 보강판을 덧대는 것이 좋습니다.

외관도
외관 사이즈
Display module and box module combination
 
패널컷 사이즈
A B C
295 (+1/-0) mm
[11.61 (+0.04/-0) in.]		 217 (+1/-0) mm
[8.54 (+0.04/-0) in.]		 1.6 to 5 mm
[0.06 to 0.2 in.]
케이블 장착시 외관도

*1: Rotation area of the fastener
*2: Pitch of center of installation fastener screws

    Copyright (C)1996-2024 Schneider Electric Japan Holdings Ltd. All Rights Reserved.